"Over Drive Off"
To turn off the maintenance light for a 2006 Scion xB, first, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. Finally, turn the ignition back on to verify that the maintenance light has reset. If it remains on, repeat the process.
Hold in the odometer knob (the one that you use to track your mileage) while you turn the key on then off and back on again, and the light should go off.
It means its time for an oil change. Can be reset by pushing the trip button until its on ODO. then hold the trip button, turn off the car and turn key to the on position without starting the car, then releasing the trip button. should reset from there.
"Scion off" and "scion on" refer to the process of grafting in horticulture, where a scion (a young shoot or twig) is attached to a rootstock (the lower part of a plant). "Scion off" indicates the removal of the scion from its original plant, while "scion on" refers to the successful attachment of the scion to the rootstock. This technique is commonly used to propagate desired plant varieties, combining traits from both the scion and rootstock for improved growth and fruit quality.
30% off for 2d Ignition keys10% off for Scion car keys
20% off for scion car keys30% off for second Ignition key
It's a common problem with Scion XB's. I have the same year and the same thing happened to me. I researched it quite a bit before taking it to the shop and from what I could tell, often this is a vacuum leak. And that was exactly what is was for me. Not typically an expensive fix other than the diagnostic fee.
How do you turn off the check engine light off and the tire pressure light off the air bag light off
To reset the airbag light on a 2004 Scion xA, first, ensure the ignition is turned off. Then, locate the OBD-II port under the dashboard and use an OBD-II scanner to read the trouble codes; clear them to reset the light. Alternatively, you can disconnect the car battery for about 10 minutes to reset the system. Remember to reconnect the battery and check if the airbag light remains off after starting the vehicle.
To reset the service light in a 2008 Scion xD, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds, then turn the ignition off. Start the engine to ensure the service light has been reset successfully. If the light remains on, repeat the process.
The phrase 'give off light' means to have a lot of light.
To reset the maintenance required light on a 2010 Scion xB, turn the ignition key to the "ON" position without starting the engine. Press the gas pedal three times within five seconds. After releasing the pedal, the maintenance light should turn off. If it doesn't reset, repeat the process.