answersLogoWhite

0

RPM = Rotations Per Minutes. the higher the rotation speed, the faster your computer can read/find your files.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How much oil pressure should your 2004 Corvette Have?

Anywhere from 35-65 psi. Higher psi at higher RPM's. Lower at lower RPM's.


What does RPM in a car mean?

RPM is short for Revolutions Per Minute. It is the measurement of how many times your engine is rotating each minute. As you accelerate, your RPM will increase until the next gear is selected, lowering the RPM. RPM is the whole reason for transmissions: if there was only one gear the RPM would get so high that the engine would become damaged. By shifting into higher gears, the RPM is lower and you get better gas mileage.


What corvette rear axel gear gives better mpg 2.56 or 2.73?

THE LOWER THE NUMBER THE LOWER THE RPM'S. THUS BETTER MILLAGE. SO THE 2.56 WILL GIVE U LOWER RPM'S. THUS BETTER GAS MILAGE.


What is standard of rpm while driving?

depends on what car and what engine, typically if your cruising on a freeway, you will be running at half RPM or at the most 3/4, but the lower RPM the better with that you get better gas mileage.


Can your gas mileage suffer when traveling at highway speed?

The higher the speed the lower the miles per gallon will be. Higher speeds mean that the engine rpm's are also higher ... higher rpm's means greater gasoline consumption. Try going 10 miles and hour less and run a test on your mileage ... you might be surprised at the results.


What is the normal RPM at idle on 1999 cavalier?

650-700 rpm.. If any lower it tends to shake and vibrate to much.. and anything higher is unnecessary.


What RPM is the cheapest in driving cars?

Driving on lower RPM's will reward you with higher gas mileage in addition to putting less wear on the engine. So, low RPM will be cheaper in the long run.


Can a pin hole leak in a head gasketexhaust side cause a rise in the operating temperature as higher rpm is introduced and then lower again as rpm is reduced?

Yes.


Is 310 torque at lower 1750 rpm better than higher torque 342 at higher rpm 6200 on a car?

It depends on what the car is being used for. The 310 at 1750 would be better for stop / start traffic, and most "real world" situations. 342 at 6200 would hardly be used unless you were driving a race car. (Or enjoy revving out your engine every gear change).


What benefit does an overdrive manual transmission provide?

An overdrive transmission adds an additional gear ratio to the vehicle. This additional gear allows the engine RPM's to be lower, resulting in better fuel economy at higher speeds.


What are the advantages and disadvantages of using a higher vs lower gear ratio in a vehicle's transmission system?

Using a higher gear ratio in a vehicle's transmission system can provide better fuel efficiency and lower engine RPM at higher speeds, but may result in slower acceleration. On the other hand, using a lower gear ratio can improve acceleration and towing capacity, but may lead to higher fuel consumption and engine noise at high speeds.


What does it mean when the idle control system rpm higher than expected?

You may have a vacuum leak.