The Crankshaft position sensor, or (CKP) monitors the Crankshaft position and No#1 cylinder piston position while the engine is running. this information is sent to the engine's ECM. ( Electronic Control Module) the ECM then uses this information to calculate several operating parameters for engine performance but mostly it is used to operate the engine's Ignition system ( coil (s) and spark plugs). back in the day' you could replace your "points style distributor" for an "Electroinic-Ignition system" very much like todays MSD distributors. many of those used a Cam-sensor which essentially performed the same function. some used a Crank-sensor instead. basically:these sensors tell the ECM when to fire the spark plugs. before that it was all done with a set of "points" inside the distributor. hope this helps
Where is the crank shaft sensor located in a Audi a6
One symptom of a bad crank shaft sensor is the car having trouble starting. The car stalling and backfiring are other symptoms of a bad crank shaft sensor.
The crank sensor on a 2001 Malibu is located on the bottom of the engine near the crank shaft. It monitors the rotation and speed of the crank shaft.
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
That year model does not have a crank sensor.
No
the crank sensor is located just behind the crank shaft pully of the engine.
The crank shaft positioning sensor is behind the starter. A real bear to get to.
The crank shaft sensor on a 2000 Chevy Suburban is located on the bottom of the engine, near the oil filter. It constantly monitors the crank shaft and updates the vehicle's computer of its status.
Where is the crank shaft position sensor on a 2001 Nissan Pathfinder v6?
crank shaft sensor is near the oil filter. I have the repair manual but I am unable to past the page in here.
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft