0
What else can I help you with?
What happens when you put a tire on wrong?
why/how do you think you put it on wrong?
If key is put in wrong way on 2007 S80 and can't get it out?
has anyone put the key in the ignition the wrong way and can't get it out
What is ignition cylinder?
Not quite sure what you mean, sometimes the lock tumbler that you put the key in and turn is called an ignition lock cylinder, if not that, I've no clue what you're talking about? Perhaps you could use it in a sentence or be a little more descriptive. If you reverse the words to Cylinder ignition, that would be when the fuel mixture is ignited by the spark plug.
What if the car loses all power when you put the key into the ignition Any suggestions?
Sounds like a bad ignition switch. note: the actual "switch" is different from the lock cylinder part. The lock cylinder turns the switch.
What happens if you put a heart in the wrong way?
It does not beat
Setting ignition timing BMW 6-cylinder 2.7 lt?
how to put the timing on 99 BMW 328i
What happens if i put wrong fuel in my cadillac?
Depends on what kind of "wrong" fuel you're referring to...
How do you remove an ignition tumbler cylinder from a vehicle?
on an older car you put the key on accessery, push a needle in the little hole in the cylinder then turn the key to the left and pull on the key
Where is the ignition switch located on a 1991 oldesmobile silhouette?
right thar where you put the key in it. No, that is the key cylinder. The ignition switch is located on the steering wheel column below the insulator panels.
How do you remove key switch Ford Contour?
how do I remove the key switch from a 1998 ford contour You have to remove the plastic trim around the steering column (behind the steering wheel). Put the key in the ignition cylinder and turn one click. There is a small hole on the side of the ignition cylinder, stick a small screwdriver into this hole and press hard. Pull out the ignition cylinder with the key.
What happens if you put the wrong colour antifreeze in your car?
Nothing Nothing
How do you remove the key cylinder from the ignition switch on a 1965 Chevy?
Notice a very small hole in the chrome face of the key cylinder, insert the key and turn to the ignition on position, insert a paper clip or similar object into the small hole and gently push in as you turn the key to the start position. This will release the cylinder and allow you to pull it straight out. Disconnect the negative battery post before you try this. The above answer is wrong! Put ignition key into cylinder, turn the cylinder as far counter clock wise as possible. Install a straightened paper clip into the small hole on the chrome face of the key cylinder. Push the paper clip into the cylinder. (You will feel as "SPRING LOAD") Keep pressure against the spring load & turn cylinder slightly some more counter clock wise. While holding counter clock wise pressure remove the paper clip & turn cylinder counter clock wise until it will go no furthur. At this point pull the ignition cylinder out. BINGO!
