Throwing water on your ignition coil can cause several issues, as ignition coils are designed to operate in dry conditions. Water can create a short circuit, potentially damaging the coil and disrupting the electrical flow needed for proper engine operation. Additionally, moisture can lead to corrosion over time, further impairing performance. It's best to keep ignition components dry to ensure optimal function.
Nothing.
Literally if u touch the ignition coil on terminals u get shock that is back E.M.F. when the spark plug fires
When an ignition coil goes bad the car will not run right, or not at all. An intermittent coil will cause shudder, or a jerking motion. When the coil has no output then the cylinder that the coil feeds cant burn the fuel and cause power.
Nothing. Just dry it off an it will be fine.
The ignition coil is inside the ignition distributor.
No. The coil provides the spark and the module tells the coil when to spark.
A broken coil spring will cause the effected corner of the vehicle to drop. A broken ignition coil will cause the engine to misfire (coil on plug application) or cease to run.
The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.
check the ignition coil - usually it is weak when this happens
cracked distributor. I had the same problem when it got wet. It was the ignition coil, a common problem with these cars. You are getting water in your ignition coil, probably due to a crack. You can pay $300 for a new coil and install yourself (pretty simple, just remove and replace) or fix the cracked coil with epoxy.
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
1999 Alero how do i test ignition coil pack