You need a certain tool to pull window handels - looks like a fork, you can buy at most auto part stores.
there are screws in the door, and holding the handle on. You can get to the ones holding on the handle by pulling off the covers on each side of the door handle inside.
The 1989 Chevrolet Cavalier fuse panel can be found beneath the drivers side dashboard. The fuse panel will be located at the far left of the dashboard.
You can put a manual rollup window back on track, in your 1994 Chevy Cavalier, by removing the inside door panel. The window track is easily visible with the door panel removed.
drivers side footwell behind panel by bonnet release lever drivers side footwell behind panel by bonnet release lever
Remove the 1997 Chevrolet Suburban drivers side door panel. The window mechanism will be visible. Place the new window into the window track. Secure the window to the track.
There should be some screws of some sort in the door panel. there should be one in the interior door handle, and one in the ashtray console if applicable. when you get the screws out, you should be able to slide the panel up. in order to get to the door handle, the window will need to be up. i
in the fuse panel drivers side behind the door marked HORN
TAke off the window regulator handle and door handle then remove all of the screws you can find at the corners etc then remove the retainers around the sides and bottom of the panel. This requires a special tool availavle at parts stores.
Remove the inside door panel of your 2002 Chevy Cavalier. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
in the fuse panel located in the drivers doorjam on the left end of the dash
You can replace the inside drivers door handle by removing the door panel. With the door panel removed the door handle mechanism will be visible. Remove the linkage from the door handle. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
First remove the Window Crank Handle. Then remove all of the screws you can find, 1 for the door release, 1 for the door grip, and 4 for the door panel. Pop loose all of the lower door area, and carefullyremove the door panel. Remove the plastic behid the door panel, SAVE IT!!. With the window all of the way down, remove the screws that hold the window in and remove the window. Revers to reinstall, being sure to locate the new window into the grooves for that.