answersLogoWhite

0

A good rule of thumb is that the exhaust flue for an oil furnace should vent to the exterior of the building rather than the interior. This is crucial for ensuring that harmful gases, such as carbon monoxide, are safely expelled outside rather than circulating within the living space. Proper venting helps maintain indoor air quality and prevents potential health hazards. Always consult local building codes and a professional for specific installation guidelines.

User Avatar

AnswerBot

4d ago

What else can I help you with?

Related Questions

What is A good rule of thumb is that the exhaust flue for an oil furnace should?

A good rule of thumb is that the exhaust flue for an oil furnace should be at least 6 inches in diameter and made of a non-combustible material, such as stainless steel or galvanized steel, to ensure safe venting of combustion gases. The flue should also have a slope of at least 1/4 inch per foot to facilitate proper drainage of condensate. Additionally, it is important to maintain the flue to prevent blockages and ensure efficient operation. Always consult local building codes and manufacturer guidelines for specific requirements.


How many hours on a furnace filter?

Changing your furnace filter is critical to maximizing the life of your furnace and central air conditioning system. Replacing pleated filters every three months is a good rule of thumb. Purchase enough filters for a year and mark your calendar. This will help maintain your appliances. If you have pets or smoke, you should consider buying an upgraded quality of filter and, maybe, replace it more often.


How much space do you recommend there should be at the end of your trainers?

There should be about a thumb space from the end of your nail to your thumb knuckle


Can a nine year old suck their thumb?

They CAN suck their thumb, however by that age, they should have grown out of it.


It Hurts in my thumb when I ice my thrown out shoulder what should I do?

If your thumb hurts when you put ice on your thrown out shoulder, you should protect your thumb from the cold ice. Put on a glove or wrap a towel around your thumb. If your thumb hurts from simply holding the ice at a certain angle, then try to attach the ice to your shoulder with a sling.


Which finger should you not use when taking pulse?

The thumb because it has a pulse of it's own.


What should you thumb do doing a handshake?

Your thumb should be relaxed and in line with your fingers. Avoid pressing your thumb against the other person's palm, as this can feel uncomfortable. Maintain a firm but not overpowering grip during the handshake.


Where is the 02 sensor on a 2000 Pontiac grandam?

Look for a metal thing about the size of a thumb screwed into the exhaust system near the engine end.


Where should the thumb placement be on the guitar for optimal playing technique?

The thumb placement on the guitar should be behind the neck, opposite the fingers, for optimal playing technique.


How do you calculate arc length between electrode and charge in arc furnace?

Arc Length depends on the secondary voltage of furnace transformer. Thumb rule is for 500V the Arc length would be 500mm(20"). The purpose of arc length is to give maximum power to the melt, without arc flare. -


Can you measure pulse by your thumb?

When you put your thumb over a vein sufficiently close to the surface of your skin, you should feel a gentle throbbing underneath your th8mb. The throbbing should be steady. This is your heartbeat. If you count between the beats you get your pulse rate.


How many btu furnace to heat a 3200 sq ft home in upstate NY?

A general rule of thumb in estimating the size of furnace needed to heat a home is to find the square footage of the home, and multiply that by 45 BTU (British Thermal Unit). For a 3200 square foot home a furnace somewhere in the range of 144,000 BTU would be a reasonable estimation of the furnace size needed to heat the home. To find the most efficient furnace for any given home, however, it would be best to contact an HVAC professional who can perform a load-calculation.