You only torque them to 12 ft. lbs. Start in a corner after there all snug and go clock whys torquing them
65ft. LBS.
The oil drain plug on a 1994 Chevy 350 is on the underside of the motor. Look for a bolt in the very center of the bottom of the engine.
the oil pump securing bolt is a 7/16-14 thread bolt x 2- 3/8 inch. long. it should be torqued to 60-70- ft. lbs. of torque
all oil pans go to 10 ft lbs.
65 lbs
7/16-14
In the oil pan @ rear of motor. It's held in with 1 bolt and has a pick up tube attached to to it (its round with a screen in it).
Lubricate each bolt with engine oil. Torque the bolts lubricated with oil to 3 lb/ft of torque and no more. Run them all down finger tight, and then evenly tighten them down. Do it in a X pattern. The key is to go slow and tighten them all evenly. Do not exceed 3 lb/ft and make sure to lube each bolt with oil and nothing else. 3 ft./lbs. is not even worth messing with i would just snug them down. make sure the gasket hasn't moved out of place.
no
how to install the oil pressure gauge on a Chevy 350 small block
1976 Chevy 350 engine should take 5 qts engine oil with filter change.
The distributor and the oil filter.