code 700 is a general transmission code, there should be other codes along with it, such as 732, etc which would pinpoint the area of concern
its the code for transmission fluid pressure sensor
P0736 DODGE - Gear Ratio Error In Reverse GearPossible causes- Low transmission fluid level- Dirty transmission fluid- Shift solenoids- Transmission mechanical problems- Transmission hydraulic control circuit
The ECU fault code PO753 refers to the Transmission 3rd to 4th gear Shift Solenoid. This is part of the Transmission Relay Circuits. To repair this will require knowledge of the transmission. I suggest unless you are knowledgeable you take this to a transmission professional for repair.
P0700 just reads as code present in the transmission computer. You need to have the transmission computer checked for codes to know possible causes.
The computer has detected a malfunction and set a trouble code. You need to have it checked for codes.
It's a solenoid inside your transmission, you will have to take it to some place lie Aamco for more.
Trouble code P0700 means: Automatic Transmission Control System Malfunction You need to check the TCM for codes
Input speed sensor failure. This is the two wire sensor between and below where the transmission cooler hoses hook to the transmission case.
Could beLow transmission fluid level,Dirty transmission fluid,Bad shift solenoid(s),Transmission mechanical problems,Transmission hydraulic control circuit.Start with checking the fluid level then a fluid flush.
Both codes involve the transmission. The P0700 is the code for the computer not being able to communicate with the transmission control unit (TCM) probably from a corroded connection or faulty module. The P0750 code is the transmission shift solenoid not connecting or open, which could be another connection problem or a worn-out coil. any good transmission shop can fix both and service the transmission while at it.
Trouble code P1694 means: No CCD message from PCM- Aisin transmission
transmission codes