A brake tester is used to test brakes on vehicles. A brake tester is mostly used for testing the brakes of cars/auto-motives, but is also used for bikes and motorcycles.
hi
For amount check the brake fluid reservoir. For amount of life left in brake fluid, use a brake fluid tester found at the automotive stores (Autozone, Advance, NAPA).
on most cars and trucks it is located at the base of the brake pedal use multi tester to see if it bad before removing it good luck rich
earth leak or fuse if you are certain the sender switch at top of brake pedal is ok.Put tester on circuit to establish feed or no feed
hydrogen detector
You will need a small electrical multi-tester to test the switch. Set the tester to "ohms". Disconnect the wiring from the switch. Touch one of the tester leads to one side of the switch and the other lead to the other side. Your reading should be zero. Have a friend depress the brake pedal, and the needle on the meter should swing left to right. If the needle does not swing then the switch is bad. If it swings then the problem is elsewhere in the wiring. The multi-tester can be found at hardware stores, auto parts stores and department stores.
A grain moisture tester is used to determine whether the grain fields are at an acceptable moisture level. This can also be used to measure the moisture of rices and beans too.
A pH tester is used to determine the acidity or alkalinity of a substance. One can purchase a pH tester online at websites including Home Depot, Amazon and Sears.
A LAN tester is a circuit used to check the LAN cables. They run for approximately $41.00 in most electronic stores.
A basic antifreeze tester
Turn signals use a relay or 'flasher' which is usually located on or near the column under the dash. Brake lights get their power thru the brake light switch on or near your brake pedal under the dash; check it with a 12v circuit tester.
Emergency Brake, Parking Brake