answersLogoWhite

0

What else can I help you with?

Related Questions

How do I set TDC on ford 302?

Number 1 cylinder is on passenger side front of engine. Remove all the spark plugs and place you thumb over the #1 plug hole. Turn the engine until you feel the piston come up on the compression stoke. It will push at your thumb on the compression stroke. You can then insert a long screwdriver in the hole and touch the top of the piston. Turn the engine over by hand very, very, slowly until the piston is at TDC. Caution: Do not do this with the starter, turn it over by hand.


What is the clearance of piston ring to the liner in Toyota 3L?

The way the question is phrased the answer is zero. But I suspect that you mean ring gap, and rule of thumb is .002 inches per inch of bore.


What are the Difination and terms of car piston and piston parts?

One of the parts in the piston are the piston head,


Where on distributor cap for a 79 gmc350 is number one?

Number 1 cylinder is located drivers side, front of engine. Remove all spark plugs, rotate the engine by hand until # 1 piston is at TDC on the compression stroke. There are several ways to find this out. One way to find #1 on the distributor is to place your thumb over #1 plug hole and rotate the engine until you feel it pushing at your thumb. Now place a long screwdriver into the plug hole and touch the piston, rotate very slowly until the piston reaches the top. Remove the distributor cap and the rotor will now be pointing to #1.


What are bent engine pistons?

A bent engine piston is a reference to the piston rod. The piston cannot be bent, but the piston rod can be bent.


Why there is rings in piston?

The piston rings create a seal between the piston and the cylinder wall.


What are some compound words that start with the word thumb?

thumb nail, thumb tack, thumb screw, thumb print


What are the Parts of the piston?

There is the penis, the testicles, the scrotum, the prostate, the sperm duct etc.


What is the length of someones thumb?

My thumb, from the palm-thumb joint to the thumb-tip is 7.0 cm.


What is a piston seal?

A piston seal is a gasket designed to keep fluid from leaking around the piston. Piston seals are commonly used in brake calipers.


If the piston on the rear caliper screws in and out and the pad has a nipple that seats in the piston notch how will the piston twist its way out?

The piston doesn't twist it's way out. There is a ratchet screw adjustment that takes up the slack behind the piston. Screwing the piston back in resets the adjustment.


What is a piston ring compressor?

It is a spring metal sleeve that goes over a piston to compress the rings so that the piston can be install in the motor. It tightens down on the piston, forcing the rings into the grooves in the piston then you tap it into the cylinder.