answersLogoWhite

0

Amperage (energy) required to make starter turn fast enough to start vehicle usually not more than 250 amps

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

Can a low battery cause starter not to engage?

Yes. Without sufficient charge, the starter will not have enough amperage to crank.


Can a semi truck crank the engine when bettery bellow 12 volt?

Yes, so long as it has the amperage to do so.


What is the Horsepower rating for starter motor?

To determine this you will have to measure the amperage the starter draws when you crank the engine. This amperage times the voltage (12 volts) will give you the wattage. There are 746 watts to 1 HP.


What would power draw be from a new battery when you go to crank the engine?

The amperage required to turn over or crank most automobile engines is between 70 and 140 amperes. At 12 volts this works out to be 840 watts to 1680 watts of power for a few seconds from the battery.


What crank amperage should a battery have in a 93 Cadillac deville?

I would buy at least a 600 CCA battery. Buy the largest CCA battery you can find if you live in a cold climate.


What is amperage?

Amperage is electric current of flow.


What is the reason for starter motor burning?

When A Starter Burns Up, It Is Because Of Low Voltage While Trying To Crank The Engine. When Voltage Drops...Amperage Goes Up And Usually Melts The Copper Winding In The Starter Or Armature.


It is ok to use a fuse with a higher amperage rating and not ok to use a fuse with a smaller amperage rating why?

It is ok to use a fuse with a higher amperage rating and not ok to use a fuse with a smaller amperage rating why?


When a circuit is inductive the current has what voltage?

This doesn't make sense, "current" is "amperage" so the higher the voltage the lower the amperage, and the lower the voltage the higher the amperage.


What is the proper amperage to use with 3-16 7018 on 5-8 plate with 45 bevel?

There is no proper amperage...no such thing as amperage, its called current... measured in amps...


What amp wire should you use for 3000w lights?

Wire size is based on the amperage drawn. To find the amperage, the voltage must be stated. Use this formula to find the amperage. I = W/E. Amps = Watts/ Volts. Once you have the amperage, restate your question using the new found amperage or state the voltage that supplies the lights.


What is an amperage?

An amperage is the electric current's strength carried by a conductor or machine generated as measured in amperes.