The proper torque specification for the front wheel bearing assembly on a 2002 Chevy Cavalier is typically around 85 ft-lbs (115 Nm) for the hub nut. It's important to ensure that the bearing is properly seated before tightening. Always consult the vehicle's service manual for the most accurate specifications and procedures specific to your model.
Wheel bearing hubs on all vehicles has to be at least 200 foot pounds. This should be in the directions when you purchase the wheel hub
185 to 260 ft lbs this is the front center nut that holds axle and front wheel bearing together not wheel lug nuts
front bearing torque 151 ft lb rear bearing torque 63 ft lb plus 36 degrees
Front hub/wheel bearing torque is 190-210Nm.
Using new bolts, torque the front hub/bearing assembly to 96 ft-lbs.....
A torque wrench is not required to remove the bearing. It is required to apply the correct loading to a nut or bolt when assembling. Because the fixture may have been in place for some time a greater force may be needed for removal, because of corrosion or dirt, than the original torque setting applied.
It is 175 ft lbs for the front wheel bearing of a grand cherokee
2003 SATURN L 300 front axle torque spec
what is the torque on front wheel bearings for 1998 honda accord
There is one on the front passenger side and a torque strut on the front. The torque strut acts like a motor mount.
290 nm front wheel bearing 1.7 puma
It sounds like you have more probalem than wheel bearing. TAke it to a front end shop