You may need a low sill if it is difficult to lift your legs. In our tests most people preferred a sill that was no more than 200-250mm from the ground.
yes... the height is from the ground to the seat.. for example: the crf250r is 38 inches from the ground
What is the Average price of a Car Seat?
To measure the height of a bicycle accurately, use a tape measure to determine the distance from the ground to the highest point of the bike's frame, typically the top tube or seat tube. Make sure the bike is on a level surface and measure vertically for the most precise result.
To measure the height of a bike accurately, use a tape measure to determine the distance from the ground to the highest point of the bike's frame, typically the top tube or seat tube. Make sure the bike is on a level surface and measure vertically for the most precise result.
To measure the height of a bike accurately, use a tape measure to determine the distance from the ground to the highest point of the bike's frame, typically the top tube or seat tube. Make sure the bike is on a level surface and measure vertically for the most precise result.
The average seat width on airplanes is typically around 17-18 inches.
To determine the correct size of a bike for you, measure the distance from the top of the seat to the ground in centimeters. This measurement should be suitable for your height and comfort while riding.
The typical height of a toilet seat is around 17 inches from the ground.
The average cost of a love seat is 450-2,500. hope you've saved up.
10 inches from table underside to top of chair seat
Any good ground on the engine will do. Look for an unpainted surface or a bolt. transman Battery is under the rear seat try that area
The only commonality the right and left seat systems share with the doors is a ground point. Ground point "W12" is located by the center console and goes to the door switches and the seat control switch. The ground for the seat switches is poor and not allowing the seat control unit to work. When you open the door the door switch provides a better path to ground than the W12 ground point. You need to trouble shoot the ground to the switch. They are brown wires. Hope this helps.