0
What is the axial force exerted by crankshaft of a 4500 HP ENGINE rotating at 954 rpm?
To calculate the axial force exerted by a crankshaft, you would typically need additional information such as the dimensions of the crankshaft, the type of loading, and the design specifics of the engine. However, a rough estimation can be made using the engine power and rotational speed. The axial force (F) can be estimated using the formula ( F = \frac{P}{v} ), where ( P ) is the power in watts and ( v ) is the linear speed at the crankshaft, which can be derived from the crank radius and RPM. Without specific dimensions, an exact value cannot be provided.
What else can I help you with?
How does spirochetes move?
A spirochete can move by rotating its axial filaments.
What is axial alignment in rotating machines?
Shaft center to center
Which type of rotary compressor used in gas turbine?
Rotating axial compressor.
What is meant by axial displacement in steam turbine?
Axial displacement is the motion along the shaft of the turbine caused by the force exerted by the steam or by the thermal expansion of the shaft and casing.
What is the purpose of a thrust main bearing?
The purpose of a thrust main bearing is to support the axial load and limit the axial movement of the crankshaft in an engine. It ensures proper alignment and stability during operation, preventing excessive wear and damage. By absorbing forces generated during the combustion process, the thrust bearing helps maintain consistent engine performance and longevity.
How we can reduce axial thrust in centrifugal pump?
it is the bearing that holds the shafts while it is rotating.
What has the author Franklin K Moore written?
Franklin K. Moore has written: 'Research on rotating stall in axial flow compressors. Part IV. A preliminary study of three-dimensional rotating stall'
Why pole star remains stationery while earth is rotating?
Because the "pole star" is aptly named due to being located at Earth's pole. The pole is the axial point where Earth is rotating so anything located at the pole will appear as though it is stationary.
What is the difference in working between axial flow pumps and mixed flow pumps?
In axial flow pumps, fluid enters and exits along the same direction parallel to the rotating shaft giving high flow rates and low head. In radial flow pumps, fluid enters and leaves perpendicular to the rotating shaft giving high head and low flow rates. Thus, in mixed we have combined of both axial and radial.i.e.Liquid will go behind the impeller at certain angle between 0-90degrees normally below 45degree.Mixed flow replace axial when we require head not provided by the axial pump as we have to lift water from a water a lower level and then discharge it. physically,mixed flow can be identified by bellmouth(diverging converging shape) which shows its between axial and radial. BILAL BIN NASIR
What is difference between axial flow and centrifugal LVAD?
Axial flow LVADs have a propeller-like rotor that spins along the device's long axis to propel blood forward, while centrifugal flow LVADs use a rotating impeller to draw blood into the device and then expel it outward. Centrifugal flow LVADs are generally more compact and have fewer moving parts compared to axial flow LVADs.
How many stages of compresion on a j79 gas turbine engine?
The J79 gas turbine engine features a single-stage fan and a nine-stage axial compressor, which together provide efficient air compression before combustion. This design allows the engine to achieve high thrust levels and operational efficiency. Overall, the engine has a total of nine stages of compression in the axial compressor.
What country was the jet engine invented?
The Jet engine was invented simultaneously by an Englishman and German, however neither knew of each others work and they both designed a completely different engine. English Sir Frank Whittle invented the radial flow engine, whereas the German Albert Fonó invented the axial flow engine. Both engines were successful, however the axial flow princable is used mostly today.
