answersLogoWhite

0

The hardness of En8 (having quite high C - 0.40%) will be dependent upon the supply condition - Annealed, Hardened, HT etc and may vary between say about 150 BHN to 40 HRC

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is the maxhardness acheived in En8 material after heattreatment?

what is the normal hardness of en8 material


What is hardness of en8 in joules?

The hardness of a material like EN8 is typically measured using a Rockwell hardness scale (e.g., HRC or HRB), which is not measured in joules. Hardness is a measure of a material's resistance to deformation, while joules are a unit of energy. The hardness of EN8 would depend on the specific heat treatment and method of testing used.


What is hardness of en8?

The hardness of EN8 is usually between 500 N/mm2 and 800 N/mm2.


Can you get EN8 Hardness 170-220BHN?

Yes


What is the maximum hardness can be achieved in EN8 material by hardening process?

Through hardening Process & Polymer quench 20% - As quench Required hardness - 35 - 40 hrc.


Hardness difference between mild steel and EN8?

no more answers


What is the use of En8 steel?

En 8 is used for manufacturing threaded parts. because hardness of En8 never goes above appr. 30-35 HRC


In EN8 material what does EN specifies?

european norms


If a material has a hardness of 8 can it not be scratched by a material with a hardness of 7?

Yes, a material with a hardness of 8 can scratch a material with a hardness of 7, but not the other way around. Hardness is a measure of a material's resistance to scratching, so a material with a higher hardness value can scratch a material with a lower hardness value.


What is the max.hardness acheived in En8 material . Can anyone tell me what is EN8 Heat Treatment Standard conditions?

normally in soft cindition (before heat treatment) it is 200 to 240 BHN


What is tensile strength of EN24 series of steel?

the yield strength of EN8 material is 465MPa.


What is the allowable bending stress for EN-8 shaft material?

allowable bending stress for en8