0
Code p0234 means turbo overboost, my truck just started doing this tonight and I'm doing research to try and figure it out. I found already that p0234 has to do with the wastegate. I found mechanical wastegate failure. I'm not sure what that means but I'm doing more research, ill post again when i find out more
What else can I help you with?
What causes Code P0234 on a 2001 Dodge Ram 2500 diesel auto?
Trouble code P0234 means:Engine overboost condition
What does the code P0234 mean on a Volvo 2002 S80?
Trouble code P0234 means:Engine overboost condition
What does the code p0234 mean on a Volvo 2001 s80?
turbo overboost
What is OB2 code P0753 on a dodge ram cummins 2000 47re?
Trouble code P0753 means:Shift solenoid A electrical
What is the code P1740 on a 2006 dodge ram cummins?
Trouble code P1740 means: TCC Solenoid or Overdrive Solenoid Performance
What does p done code mean for 2001 dodge ram cummins diesel?
Its clear no codes everything ok
1998 Ford 5.9 Cummings died out while driving and will not start back up the code that I am getting is Code 2?
since when did ford use a 5.9 cummins. 5.9 cummins is a dodge engineford in 1998 had 7.3 powerstrokefrom there it went to 6 lt then to a 6.4
What does 2001 dodge cummins p1693?
P1693 : Dtc detected in the companion module. You need to check the Ecm and Pcm for codes. Which ever did not have p1693 will have a code.
How do you reset the ABS light on a 2003 Dodge Intrepid?
After checking the code, and repairing the cause, you clear the code with a scan tool.
How do you reset the 4x4 service light on a 2001 dodge durango?
You need to have the code read and repair the cause.You need to have the code read and repair the cause.
Why does my check engine light not go off after code is erased in a 1996 dodge caravans?
If the cause of the code is not repaired, erasing it will not do any good.
How do you reset a fault code in 2001 dodge Cummins diesel?
To reset a fault code in a 2001 Dodge Cummins diesel, you can use an OBD-II scanner to read and clear the codes. Connect the scanner to the OBD-II port, turn the ignition to the "On" position without starting the engine, and follow the scanner's instructions to erase the codes. Alternatively, you can disconnect the battery for about 15 minutes to reset the engine control module, which will clear the fault codes. However, ensure to address the underlying issue before resetting to avoid reoccurrence.
