0
What else can I help you with?
Coil gap 6.5 lawn boy mn10323?
Air gap between coil module and flywheel should be .010 inches.
What is the air gap setting on a pickup coil for an 1982 dodge ram van with a 360 engine?
1982 318 pick up coil gap
What is the gap between the coil and the fly wheel on a John Deere L100?
A business card. GAP
What is gap between flywheel and coil on a Murray 17hp riding lawnmower?
You can use a standardbusiness card for the gap.
What is the gap setting between flywheel and coil on a small engine 3tpxs1481ba?
What I do at the shop is fold abusiness card in half . Put it in between the Coil and Flywheel. Bring the magnet around to Coil and tighten screws down. Perfect gap!
What may cause shorted ig coil on cyl?
inferior part design and sometimes a incorrect spark gap or worn plug can overwork coil a larger gap can double the the voltage needed to jump the gap causing the coil to run hot. ford is know for coils dropping like flys
What is the gap on lawn mower torque coil?
ktungutngutbh sluck
Point gap spacing for five HP Briggs and Stratton motor on the flywheel to coil?
I think what you are wanting is the air gap between the flywheel and the coil . The gap is somewhere around .002 in , but if you will take 2 matchbooks take off the covers and use them for spacers between the coil legs and the flywheel . Role the flywheel around till the magnet pulls the coil in . Place the matchbooks between the coil arms and the flywheel and tighten the screws . Check the spark plug and make sure you have good fire .
What is Ignition Coil gap setting toro mower?
For most small 4 cycle cylinder engines using a magneto and a coil to provide electricity to feed the spark the gap is .006 to .010.
How do you set coil and pulley gap on home lite25cc weed eater?
To set the coil and pulley gap on a Homelite 25cc weed eater, first, remove the spark plug and access the ignition coil. Place a thin business card or feeler gauge between the coil and the flywheel, then adjust the coil until it lightly touches the card. Secure the coil in place and remove the card, ensuring a proper gap is maintained. Finally, reassemble the components and test the weed eater to ensure it starts smoothly.
How do you sett gap between flywheel and coil?
The coil has two bolts to hold it in position. Loosen both bolts, place a .010 - .014 feeler gauge (or business card) between the coil and flywheel, and tighten bolts. The size of the gap determines the timing of the engine.
Just replaced head gaskets on 96 tbird 6-cylinder now you get no fire to plugs but your coil reads 11 volts when cranking engine any sugestions?
Sounds like the coil. The high side of the coil should be 35~70 kilo volts. 11 volts will not jump the spark gap. http://www.marksatterfield.com
