The ignition coil gap for a Stihl MS250 chainsaw is typically set to approximately 0.2 mm (0.008 inches). This gap ensures proper spark generation for efficient engine performance. It's important to check the gap periodically and adjust it if necessary during maintenance. Always refer to the owner's manual for specific recommendations and guidelines.
5 to 14 thousandths
The ignition coil gap for a Stihl 024 chainsaw is typically set to around 0.2 mm (0.008 inches). This gap ensures proper spark generation for efficient engine performance. It's important to use a feeler gauge to accurately measure the gap when adjusting. Always refer to the owner's manual for specific guidance on your model.
The gap of the points on a 020 Stihl chainsaw typically refers to the ignition timing or the gap between the ignition coil and the flywheel. For the Stihl 020 model, the recommended gap is usually around 0.2 to 0.3 mm (0.008 to 0.012 inches). It's important to consult the specific owner's manual for your chainsaw for precise specifications. Proper gap settings ensure optimal engine performance and reliability.
The correct ignition coil gap for a Stihl TS800 concrete saw is typically set to 0.2 mm (0.008 inches). It's important to ensure this gap is maintained for optimal engine performance and reliable ignition. Always refer to the specific service manual for your model for the most accurate specifications.
At your local Stihl dealer
The coil gap for a Stihl BG75 blower is typically set at around 0.2 mm (0.008 inches). This gap is important for proper ignition and optimal engine performance. Always refer to the owner's manual for specific instructions, as adjustments may vary based on individual engine conditions.
There is a grounding strap beneath the starter that serves as the circuit between the vibration-mounted handle and the engine. If you take the handel apart, you will be sorry. Look for the broken wire at the coil in lower front corner first.
The ignition coil is inside the ignition distributor.
No. The coil provides the spark and the module tells the coil when to spark.
The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.