pressure-relief valve
Check valve
No, there should not be pressure in the radiator after cooling down. If there is still pressure, it could indicate a problem with the radiator cap or the cooling system, such as a leak or a failing pressure release valve.
Locate a small wing nut looking valve on the bottom driver side of the radiator there should also be a small hose that runs from the valve up to a clip on the side of the radiator this is the drain hose Locate a small wing nut looking valve on the bottom driver side of the radiator there should also be a small hose that runs from the valve up to a clip on the side of the radiator this is the drain hose then what
The radiator cap controls cooling system pressure.The radiator cap controls cooling system pressure.
Radiator Cap?
The radiator drain is on the bottom of the radiator. It is a small petcock valve.
The low pressure valve for the refrigerant is different depending on if you have rear AC or not. With Rear A/C: The High pressure valve is located just to the left of the radiator cap. The Low pressure valve is located on the dryer (the large silver can) right beside the radiator cap. Without Rear A/C: The high pressure valve is located just to the left of the radiator cap. The low pressure valve is located in the line between the compressor and the dryer, against the firewall, above the motor (it is hard to see and access). ***WARNING*** Overcharging your system could result in an explosion.
sounds like pressure relief valve if replacing the valve doesn't stop the leaking you may have to much pressure in your cooling system mainly a Head Gasket leak.
There should be a small valve at the bottom of the rad.
It's a valve that opens or closes flow through a radiator
The pressure release valve on a Chevy Tahoe is typically located on the fuel rail, which is situated on top of the engine. It is a small metallic valve that can be identified by its Schrader-type design. To relieve fuel pressure, you can press the pin in the center of the valve, but it's important to take precautions to avoid fuel spray. Always refer to the owner's manual for specific instructions related to your model year.
To adjust water pressure using a water pressure adjustment valve, you can turn the valve clockwise to increase pressure or counterclockwise to decrease pressure. Make small adjustments and test the pressure until it reaches your desired level.