0.008intake 0.009exhaust
Also,do you adjust them warm or cold?
Intake is .002-.004 inches and exhaust is .006-.008 inches when cold.
The tappet (valve clearance) settings for a Nissan 2.0 engine can vary depending on the specific model and year. Generally, for many Nissan 2.0 engines, the intake valve clearance is typically around 0.10 mm (0.004 in), while the exhaust valve clearance is around 0.15 mm (0.006 in). Always refer to the specific service manual for your vehicle for the most accurate specifications and procedures.
The valve clearance for the Nissan PD6T engine is typically set at 0.15 mm (0.006 in) for both the intake and exhaust valves when the engine is cold. It's essential to check the specific service manual for your vehicle, as clearances can vary slightly based on model year and specific configurations. Regular maintenance of valve clearance helps ensure optimal engine performance and longevity.
THE VALVE CLEARANCE ON THE 90 TRX300 IS 6/1000 COLD FOR BOTH INLET AND EXHAUST.
.16 of an inch both for intake valve and exhaust valve [cold]
Straight out of the original 1978 Manual: Intake Valve Clearance - Cold: 0.18mm or 0.007" Intake Valve Clearance - Hot: 0.20mm or 0.008" Exhaust Valve Clearance - Cold: 0.30mm or 0.012" Exhaust Valve Clearance - Hot: 0.33mm or 0.013" The manual states these specs are not the same for the 2T-G motor, only the 2T-C
To adjust the valves on a 1983 Nissan Datsun 200SX, first ensure the engine is cold. Remove the valve cover and use a feeler gauge to check the clearance between the rocker arm and the valve stem for each cylinder. Adjust the clearance by loosening the lock nut on the rocker arm and turning the adjustment screw until the correct clearance is achieved, then retighten the lock nut. Repeat this for all cylinders, then reassemble the valve cover.
.16 of an inch both for intake valve and exhaust valve [cold]
It is 0.40mm "Valve clearance (at cold) Intake mm(in.) 0.40 (0.0157) Exhaust mm(in.) 0.40 (0.0157)
0.40mm for both inlet and exhust when cold on 4jb1, 4jh1 engines
How to check valve clearance on 3E Toyota engine