answersLogoWhite

0

What else can I help you with?

Related Questions

How do you turn on an air compressor?

To turn on an air compressor, first plug it into a power source. Then, switch the power button to the "on" position. Adjust the pressure settings if needed, and allow the compressor to build up air pressure before using it.


Why is there too much pressure in cooling system in Detroit 60 series?

The Detroit 60 Series engine is known for having issues with excessive pressure in the cooling system due to a variety of reasons. One common cause is a malfunctioning pressure relief valve in the cooling system, which can lead to a build-up of pressure. Another possible reason is a faulty head gasket, which can allow combustion gases to enter the cooling system and increase pressure. Additionally, a clogged or restricted radiator can also contribute to increased pressure in the cooling system. Regular maintenance and inspections can help identify and address these issues to prevent damage to the engine.


What does antisurge valve do in compressors?

The compressor antisurge valve opens to bypass flow from discharge to suction. This allows the compressor to flow through bypass and keeps the compressor from surging (reverse flow thru compressor). The discharge pressure does not continue to build due to closed discharge conditions.


Why does the AC compressor start after 2-3 minutes?

The AC compressor may start after 2-3 minutes to allow the system to build up pressure and reach the optimal operating conditions for cooling.


Why could a turbocharger be surging?

Compressor surge is when the air pressure after the compressor is actually higher than what the compressor itself can physically maintain. This condition causes the airflow in the compressor wheel to back up, build pressure, and sometimes stall. Common conditions that result in compressor surge on turbocharger gasoline engines are: * A compressor bypass valve is not integrated into the intake plumbing between the compressor outlet and throttle body * The outlet plumbing for the bypass valve is too small or restrictive * The turbo is too big for the application


I have a doubt in safety air pressure relief valve that is how to evaluate the performance of the pressure relief valve?

Make enquiry's with the manufacturer of the compressor and get the max pressure rating. Then let the pressure in the tank build up to that level. If it does not open get a new valve


Where is the compressor cycling switch on a 2001 Chevy Tahoe?

It isn't so much a "cycling switch" as a pressure sensor. When refrigerant pressure drops below a specific pressure the sensor turns the compressor off. Since the sensor is on the "low side" of the refrigeration system, pressure can drop once the compressor pumps refrigerant to the "high side", then once the refrigerant is allowed past the orifice, the pressure will build up again on the "low side", and the compressor will briefly turn back on. If that's what's going on with your AC system, have the refrigerant tested and add some if necessary. That SHOULD solve your problem.


What will happen if compressor is started with condenser fan switched off?

If the condenser fan is switched off while the compressor is running, the heat transfer process in the condenser will be disrupted. This can lead to the compressor overheating, reduced efficiency, and potentially a system failure due to high pressure build-up. It is important for both the compressor and condenser fan to operate properly for the air conditioning system to function effectively.


Why does pressure build on low side after the engine reaches normal operating temperature and cause the compressor to disengage on a 2000 Jeep Chero Electric condensor cooling fan does not kick on.?

Could be due to the fact that cooling fan is not working and excessive temperature is causing pressure rise.


What are the parts of refrigeration compressor?

The parts of a hermetic (sealed) reciprocating compressor is as follows; motor, crankshaft, bearings, valves, and pressure relief valve and piston(s). there are other smaller parts that can be named but these are the main players. The hermetic scroll compressor is a little different than the reciprocating compressor because it uses an orbiting scroll and a stationary scroll to compress the refrigerant instead of pistons. This is why a scroll compressor cannot run "backwards". The scroll compressor also has an oil pick up tube which differs from a reciprocating compressor. Now a "semi-hermetic" compressor is build like a small engine. It has an oil pump, reed valve plate, unloaders, pistons, bearings, etc. A screw compressor is in a class all to itself.


How often should the ac clutch on a 92 explorer kick in?

Depends on ambient temperature and level of refrigerant charge low charge will not build sufficient head pressure to turn compressor off high charge will cause high head pressure and therefore a "short run" cycle


Why does the aircondition on the 2001 x terra keep cuting off and on?

If the compressor keeps cutting on and off its supposed to do that for fuel economy. If the air conditioning starts up for a little while then stops for a long period of time its low on refrigerant. The pressure will build up and trip the sensor to make the compressor to start back up.