answersLogoWhite

0

on the drivers side of the transmission about half way up there is a plug usually it is a 3/8 or 1/2 inch drive it can also be square ,remove the plug if no fluid runs out stick your finger in the hole if you can touch fluid it is full

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What oil goes into a 1929 Ford Model A rear end and tansmission?

600w and do not over fill.


Why is your transmission oil or gear oil leaking from your 92 Toyota tercel?

THE BOLT FROM THE MANUEL TRANSMISSION FELL OUT lost all the gear oil


How do you fill up gear box oil on clk 230?

show how to change oil gear box


Where do you fill gear box oil 1993?

A 1993 What


Where to fill gear oil for Toyota MR2?

To fill the gear oil for a Toyota MR2, locate the transmission fill plug, which is typically found on the side of the transmission case. Use a funnel with a hose to pour the gear oil into the fill hole until it reaches the level of the fill plug. Ensure the car is on a level surface for accurate filling. Always refer to the owner's manual for the correct type of gear oil and specific procedures for your MR2 model.


How do you fill gear oil on Honda ATV?

To fill gear oil on a Honda ATV, first, locate the gear oil fill cap, typically found on the side of the transmission case. Remove the cap and use a funnel to pour the recommended type of gear oil into the fill hole until it reaches the specified level, usually just below the fill neck. Replace the cap securely after filling. Always consult your owner’s manual for specific oil type and capacity information.


Where do you put gear oil in a kawasaki mule 600?

To add gear oil to a Kawasaki Mule 600, locate the gear oil fill plug on the front differential. Remove the fill plug using the appropriate tool, and then use a funnel to pour the recommended gear oil into the opening until it reaches the proper level, usually just below the fill hole. Always check your owner's manual for the specific type and amount of gear oil required. After adding, replace the fill plug securely.


How much gear oil to you need to fill the rear gear case on a Honda rancher 2000?

To fill the rear gear case on a 2000 Honda Rancher, you typically need about 0.8 to 1.0 quart of gear oil. It's essential to use the recommended type of gear oil, usually a hypoid gear oil with a viscosity of 80W-90. Always check the owner's manual for specific requirements and ensure the fluid level is correct by using the fill plug.


What oil is in manuel gear box?

Any oil with SAE 80W mark on it (in very cold climate SAE 75W).


Where do you put the oil in for a gear box peugeot 206?

remove plastic nut on top of gear box and fill,, 2 litres of oil,,


Where is the gear oil filler for Mazda 121?

You must remove the speedo drive gear to fill the gearbox.


Where do you fill the gear oil in a 200sx 97 manual trany?

The plug is in the front of the transmission. Get a funnel and fill it up until oil comes out.