0
What else can I help you with?
Where do you hook up a oil pressure gauge 92 acura gsr 1.7?
To hook up an oil pressure gauge on a 1992 Acura GSR with a 1.7L engine, locate the oil pressure sending unit, which is typically found near the oil filter or on the engine block. Remove the existing sending unit and install the oil pressure gauge adapter in its place. Then, connect the gauge line to the adapter. Make sure to secure all connections and check for leaks before starting the engine.
Where does the carburetor hook in to 1986 Honda dirt bike?
it hooks on to the engine block and atteaches to the gas line
Where is the relief valve for fuel line on 1995 Chevy silverado?
It does not have one. Just loosen the fuel line up on the filter just a little bit and the fuel pressure will leak off. You did not say what you are doing with it are what kind of problem you are having, You may need to ask your question again. If you are trying to check the fuel pressure, It does not have a valve on it to hook gauge to. You will need to unhook fuel line from back of TBI / Throttle body housing and hook gauge in there. Then turn key on and it should read 9 to 13 LBS. of fuel pressure. No more and no less.
How you could wring slip gauges together?
Wiping a clean gauge block across an oiled pad.Wiping any extra oil off the gauge block using a dry pad.The block is then slid perpendicularly across the other block while applying moderate pressure until they form a cruciformFinally, the block is rotated until it is in-line with the other block.
How do you put a fishing hook on a fishing line?
To put a fishing hook on a fishing line, first thread the line through the eye of the hook. Then, make a loop with the line and pass the hook through the loop. Pull the line tight to secure the hook in place.
How do you tie a fish hook to a line?
To tie a fish hook to a line, first thread the line through the eye of the hook. Then, make a loop with the line and wrap it around the hook shank. Finally, secure the knot by pulling the line tight.
How do you tie a hook on a line?
To tie a hook on a line, first thread the line through the eye of the hook. Then, make a loop with the line and wrap it around the hook several times. Finally, secure the knot by pulling the line tight and trimming any excess.
How do you install a fuel pressure gauge on a 1984 corvette?
Crossfireinjection.net sells some nice hard piped kits that hook between throttle bodies. Otherwise you have to install a t with a shrader valve on the rubber fuel line, preferrably after the filter. Then hook a gauge 0-15 psi preferrably to the bull end of that T.
How do you install boost gauge on Toyota supra?
if it is a manual gauge it is as easy as following the directions. hook up a wire for the light, a ground and the vacuum hose spliced somewhere into a current vacuum line with the T that is most likely provided.
What fastens the gauge line to the end fittings of a gauge line?
Ghji
How do you tie a fishing line hook knot?
To tie a fishing line hook knot, follow these steps: Thread the line through the eye of the hook. Wrap the line around the hook 5-7 times. Thread the line back through the loop near the eye of the hook. Moisten the knot and pull tight. Trim any excess line.
Where does the vacuum line on a turbo350 transmission connect on a small block Chevy?
It hooks to a vacuum port on the intake manifold behind the carb.
