The A/C dual pressure switch on a 2002 Isuzu Rodeo is typically located on the receiver/drier assembly, which is situated near the front of the engine bay, close to the condenser. It can also sometimes be found on the A/C line near the compressor. To access the switch, you may need to remove some components for better visibility. Always ensure the system is properly evacuated before attempting any repairs.
There is none.
How I can replace ignition switch cylinder from Isuzu Rodeo?.
The AC low pressure valve on a 1996 Isuzu Rodeo is located in the back of the engine compartment. The valve is on the larger of the two hoses that run from the evaporator to the compressor.
Where is my filter for my 97 ISUZU RODEO
In recent experience, I have learned that a 1992 rodeo does not have a cut off switch and that on most the fuel pump is in the tank!
where is the pcv valve located on a 1995 Isuzu rodeo v6 3.2l
The cam diagram for the Isuzu Rodeo 1998 2.2 can be located at Rock Auto and Isuzu.
The EGR valve on a 95 Isuzu Rodeo is located on the back top of the engine. It resembles a cylinder.
there is not one
On a 1997 Isuzu Rodeo, the oil filter is located on the bottom front of the motor beneath the fan.
Isuzu rodeo 3.2 V6 LS.
Depending on the transmission type, the neutral safety could be located in several places on the transmission. If the switch is bad, the Rodeo could either start in any gear, or not start at all.