0
The blower resistor on a 2003 Kenworth is typically located within the HVAC (heating, ventilation, and air conditioning) system, often found behind the dashboard or near the blower motor. To access it, you may need to remove the dashboard panel or other components obstructing the area. It's advisable to consult the vehicle's service manual for specific instructions and diagrams for your model.
What else can I help you with?
Where is the heater blower resistor located in a 2003 Honda Element?
where is the heater blower resistor in a 2003 Honda element
Where is the blower resistor for a 2003 trailblazer?
The blower resistor for a 2003 Trailblazer is located under the passenger side of the dash.
Where is the blower motor resistor located on 2003 suburban?
The blower motor resistor is located under the glove compartment in a black shroud.
Where is the blower motor resistor located on a 2003 Envoy?
The blower motor resistor on a 2003 GMC Envoy is typically located under the dashboard on the passenger side. It is mounted to the HVAC housing, near the blower motor itself. You may need to remove a panel or the glove compartment for better access to the resistor.
Blower motor resistor in a 2003 mistsubishi eclipse?
where is the blower motor resistor in a 2003 Mitsubishi eclipse
Where is the blower resistor block located on a 2003 Jeep liberty?
behind the glove box
Where is blower motor resistor on 2003 Buick century?
The blower motor resister is located just below the blower motor to the left attached to the housing.........
Where is located the blower motor resistor on 2003 Toyota Echo?
Under the dash, on the passangers side.
2003 Chrysler Sebring where is blower motor resistor located?
under the dash. if you can find the blower motor then it should be right above that
Where is the resistor module located on a 2003 Chrysler town and country van?
The blower motor resistor is mounted behind the glove box door.
Where is the blower motor resistor located on a 2003 Chevrolet Impala?
It is located under the dash on the right side in the evaporator case.
How do you Replace blower resistor on 2003 Buick century?
To replace the blower resistor on a 2003 Buick Century, first, disconnect the negative battery terminal to ensure safety. Remove the passenger side lower dash panel to access the blower motor resistor, which is typically located near the blower motor. Disconnect the electrical connector from the resistor, remove the screws securing it, and replace it with the new resistor. Reassemble by reversing the steps and reconnect the battery.
