Assuming this vehicle has the 4.3 V6 engine, the coil wire is connected to the passenger side rear of the distributor cap and the other end is connected to the ignition coil on the top passenger side of the engine.
Bad coil wire, bad coil, etc...
The coil is inside the distributor. There is no coil wire.The coil is inside the distributor. There is no coil wire.
Failed coil/plug wire.
purple out of the 2 smaller wires black with white stripe is ground
To unlatch the wire harness ignition coil cassette on a 2000 Oldsmobile Intrigue, first ensure the ignition is turned off and the battery is disconnected for safety. Locate the wire harness connector at the base of the ignition coil cassette. Gently press the release tab on the connector while pulling it away from the coil to disconnect it. If necessary, use a small flathead screwdriver to assist in releasing the latch without damaging the connector.
For the coil which is closest the the radiator: first wire goes in the cylinder one (first one from the passenger's fender). Second wire in the coil goes in the cylinder #3. For the second coil which is closest the firewall, first wire starting from radiator goes in the cylinder #2 and second wire in the #4.
Mine went and the wire for it is located right near the hood latch in the front . I taced it back a litttle and sniped it so then I just pull the wire from the front to open it.
Click the link.
yes coil is a type of wire
2 screws one front and one back the coil is the thing the short wire goes to
The coil wire.
The coil wire runs from the coil to the center of the distributor cap.The coil wire runs from the coil to the center of the distributor cap.