The expansion valve in an AC system is typically located between the condenser and the evaporator. It is usually found in the indoor unit, near the evaporator coil, or in the refrigerant line connecting the two components. This valve regulates the flow of refrigerant into the evaporator, allowing it to expand and absorb heat from the indoor air.
The ac system on a Ram doesn't use an expansion valve. It uses a fixed orifice system.
Only the rear system has an a/c expansion valve an is located at the back left side next to the last row of seats,very easy to see.
There is no expansion valve. There is an orifice tue. It is located in the inlet tube of the evaporator core.
The AC expansion valve on a 1991 Toyota Previa is located near the evaporator core, typically within the dashboard area, making it somewhat difficult to access. There is one expansion valve in the system, which regulates the flow of refrigerant into the evaporator to ensure proper cooling.
Expansion valve
Where id the AC expancion valve located in a 202 gmc yukon with rear air
The expansion valve is located on the rear evaporator core, typically in a casing located under one of the rear interior trim panels.
The expansion valve on a 1997 Honda Accord AC is located in line with the tube that supplies liquid coolant to the air conditioner vapor. It is mounted right beside the tube.
I anwered this question Look at post ... "Where is Expansion valve located on 2003 Yukon Denali XL"
The AC expansion valve, also known as the thermal expansion valve (TXV), is typically located in the refrigerant line between the evaporator and the condenser in an automotive air conditioning system. It is usually found inside the cabin or close to the evaporator core, depending on the vehicle's design. The valve regulates the flow of refrigerant into the evaporator, allowing for efficient cooling. If you're looking for a specific "eclipse" related to the expansion valve, please clarify the context.
To change the expansion valve on a 2006 Chrysler PT Cruiser, first ensure the AC system is fully discharged to avoid refrigerant release. Remove the dashboard or access panel to reach the valve, typically located near the evaporator. Disconnect the refrigerant lines and electrical connector from the valve, then unbolt and remove the old valve. Install the new valve, reconnect everything, and recharge the AC system.
The freon has to be removed and the pressure released from the ac system. Then the valve can be removed and replaced. The system will need to have a vacuum pulled and freon put in again.