Check under the dash/glovebox Check under your seats and behind them as well. Last check all your Cargo areas. It will likely be around the entry for all electronics from the engine to your cab.
It's behind the glovebox if you have the nakamichi stereo
it is on the left side of the trunk behind the CD changer.
A 2007 Chevy Avalanche will only have an external factory amplifier if it is equipped with a Bose stereo system. If there is a factory amp included, it will be underneath the center console.
You should be able to find it under the front passenger seat.
The factory stereo didn't have an external amplifer.
Where is factory stereo amp located on a 2007 Cadillac cts
Yes, an amplifier can be installed on a 2000 Chrysler Sebring factory with a CD. Provided the CD drive is working perfectly.?æ
Behind the passenger kick panel
If you are trying to put in a new stereo I have your answer. The 96 continental that i have ( i am assuming that yours being a year older is the same) came with a factory amplifier. Thus, the stereo head unit is wired directly this amplifier ( unlike standard stereos which have speakers directly wired to the head unit. This amplifier is located in the trunk, you must remove the top panel in the trunk closest to the back seats to acess it. From the amplifier the wires run to the four door panel speakers. Once you acess this amplifier you can proceed with any modifications that you wish to make. mkelly12@ramapo.edu
The amplifier is mounted under the dashboard on the driver's side. It is to the left of the steering column
On a 1997 Ford Explorer, the stereo amplifier is located above the rear wheel on the passenger side. It can be accessed by removing the side panel.
To replace the amplifier in a 2008 Toyota Prius base model stereo system, you'll first need to access the factory amplifier, which is typically located under the driver's seat. Disconnect the battery to prevent any electrical issues, then remove the necessary panels and connectors to access the amplifier. Replace the old unit with a compatible aftermarket amplifier, ensuring proper wiring and connections. Finally, reassemble everything and reconnect the battery to test the new system.