The flame sensor for the model 398AAW036080D is typically located near the burner assembly. It is positioned to detect the flame produced by the burners, often mounted on or near the combustion chamber. For specific installation details, it's best to consult the manufacturer’s manual or a qualified technician, as the exact location may vary slightly depending on the specific configuration of the unit.
yes
To remove the flame sensor from a 1988 gas furnace, first, turn off the power and gas supply to the furnace for safety. Locate the flame sensor, which is typically a thin metal rod near the burner assembly. Use a wrench or screwdriver to unscrew the mounting bracket or nut holding the sensor in place, then gently pull it out. Be careful not to damage any wiring connected to the sensor.
The flame sensor on a furnace is typically located near the burner assembly, usually positioned in the path of the flame.
It tells the furnace that it lit... Hence the name Flame Sensor.
Its not a flamesensor its a pilot generater it generates a small amound of electricity to open the main valve that way if your pilot light goes out it wont let gas escape and couse a potentian explosion The above answer is not accurate unless you have a standing pilot model furnace. Then the "flame sensor is called a thermocouple, much different than the flame sensors used in Direct Spark Ignition, hot-surface and intermitant ignition furnaces. The flame sensor uses the flame of the main burner to prove flame at the circuit board by measuring conductivity to ground through the flame.
The flame sensor on your furnace is typically located near the burner assembly, close to where the flame ignites. It is a small metal rod that detects the presence of a flame and signals the furnace to continue operating.
The flame sensor is typically located near the burner assembly in gas-fired appliances, such as furnaces, water heaters, or boilers. Its position allows it to effectively detect the presence of a flame during operation. In most setups, it is mounted in a way that it can directly "see" the flame, ensuring proper safety and functioning of the heating system. Always refer to the specific appliance's manual for the exact location, as it can vary by model.
A flame sensor in a water heater detects if the burner flame is lit. If the flame goes out, the sensor shuts off the gas supply to prevent gas leaks and potential hazards. This ensures safe and efficient operation by monitoring the presence of the flame and preventing the heater from running without it.
A flame sensor is a program used to detect "flame" on various blogs or comment boxes. Various Websites may use these sensors to dish out trolls or other internet vermin. On the other hand a flame sensor is also a device used in machines that are subject to very high temperatures. For example, a flame sensor is standard in many home ovens. So this in fact is a very useful safty feature.l
The flame sensor in a typical heating system is usually located near the burner assembly or pilot light.
The water heater flame sensor detects if the burner flame is lit. If the flame goes out, the sensor shuts off the gas supply to prevent a dangerous gas leak. This ensures the water heater operates safely and efficiently by only allowing the burner to function when the flame is present.
Common symptoms of a furnace issue related to a bad flame sensor include the furnace not staying on, frequent cycling on and off, or the furnace not producing heat. Troubleshooting steps for this issue include cleaning the flame sensor with steel wool, checking the sensor's alignment, and ensuring the sensor is securely connected to the furnace.