It is located on top of the fuel pump module. You will find two electrical connections on top of the fuel pump module. One connection has four wires and the other has three wires. The one that has three wires is connected to the fuel tank pressure sensor. This sensor monitors the negative pressure in the tank during the EVAP self test mode. This sensor can be replaced without removing the tank or the module if you have nibble fingers. First purchase the new sensor and you will see how it is held in place. After disconnecting the electrical connection and spraying the area with a little lube the sensor will wiggle up and out. Recommend cleaning the area with compressed air first to avoid letting any dirt get inside the tank.
Need the engine size.
The MAP (Manifold Absolute Pressure) Sensor on a 2000 Chevy Suburban is located on the very top of the motor. It is all the way to the back of the motor. There is nothing behind it.
The 1999 Chevy Suburban camshaft sensor is located on the front of the engine. The camshaft sensor will be behind the front engine cover.
It is back by the distributor and screews into the engine just about were the distributor goes into the engine.
Where is located pressure sensor on Chevy Malibu 1999
There is two of them uder the intake
It is located on the left rear of transfer case.
It is screewed into the very back of the block, but up on top right behind the Distributor.
Inside the fuel tank.
It is located in the throttle body.
BEHIND the starter. You MUST remove the starter to get to it.
where is the oil pressure switch on a 1999 chevy surburban