answersLogoWhite

0

Its location is on the side of the engine. The hydraulic pump is connected to it. It is a long blue canister that you take the end cap off and slides out it should be metal with little pin holes in the filter there cost is about $70 bucks new.

User Avatar

Anonymous

5y ago

What else can I help you with?

Related Questions

What oil is recommended for a ford 1310 tractor?

Rotella 15-40 T6 the 1310 holds 4 quarts with filter


Where to find a video on changing the hydraulic filter on a 1958 Ford 1310 tractor?

you can look on youtube.


What oil do i use in my ford 1310 tractor?

The best oil is the rotella oil T6 15-40 weight all season. Holds 4 quarts with filter. For the ford 1310 s753 engine


What fram oil filter fits a ford tractor model 1310?

Hi, I am the tech manager at Fram. Your 1310 uses a Fram PH2951 for oil and a CG9271 for fuel filters. Thanks for thinking of fram!


What is the oil capacity for a ford 1310 tractor?

Engine crankcase capacity = 3.3 quarts without filter change, 3.7 quarts with filter change


Where is the hydraulic filter located on ford 8N tractor?

There is no hydraulic filter located on the Ford 8N tractor!


Need a hydraulic filter for ford 4500 backhoe?

Does the hydralic pump on my 4500 backhoe have an intake filter


Where is a hydraulic pump on a ford 1310 tractor?

On a Ford 1310 tractor, the hydraulic pump is typically mounted on the front of the tractor, driven by the engine. It is usually located near the front right side, connected to the engine's crankshaft. This pump supplies hydraulic fluid to the tractor's hydraulic system for operating implements and attachments. For precise location, refer to the owner's manual or service guide specific to your model.


What Oil filter fits Ford 1300 tractor?

Ihave a 1979 Ford 1300 tractor and use NAPA 1390 oil filters.


What fram oil filter will fit a ford 3000 diesel tractor?

ph8a


What is the Engine oil capacity for a ford 6810 tractor?

Without filter is 7.6 litres. With the filter is 8.5 litres


How do you rebuild hydraulic pump on ford 1310 tractor?

To rebuild the hydraulic pump on a Ford 1310 tractor, first, remove the pump from the tractor by disconnecting the hydraulic lines and unbolting it from its mount. Carefully disassemble the pump, taking note of the order of components, and inspect all parts for wear or damage. Replace any worn seals, gaskets, or components, then reassemble the pump, ensuring everything is properly aligned and secured. Finally, reinstall the pump onto the tractor, reconnect the hydraulic lines, and refill the hydraulic fluid before testing the system for proper operation.