The ignition coil on a 2006 Chevy Cobalt is located on the engine, typically mounted near the top of the engine block. It is integrated into the ignition coil pack, which can be found near the spark plugs. To access it, you may need to remove the engine cover and other components, depending on your specific engine configuration. Always consult your vehicle’s service manual for detailed instructions.
Its right above the ignition coil. Infact you have to remove it first to remove the ignition coil.
That is the ignition coil.
well it is the bottom that goes on a ignition coil and it is locoed
the number 2 ignition coil in a 2006 hyundai sonata is the middle in the front three ignition coils
The coil is attached to the top of the distributor cap.
check your ignition coil, if it's not coming out of there you need to look into a new ignition coil , check ignition circuit next
no
It is advisable to have the ignition coil grounded on a 2003 Chevy Astro. This should especially be done when you are working on spark plugs and wires.Ê
Bolt The Coil Bracket And Coil To The Block, The - Goes To The Distributor The + Hooks To The Ignition.
no
The coils are bolted to the ignition control module, there is no coil wire as such.
When you take a voltage reading at the coil with ignition on and the ignition points are open you would get the same reading on both + and - .