answersLogoWhite

0

Large light gray unit on top of the motor with the air intake snorkel leading into the front of it. It's a two piece component with the injectors internal, fuel regulator also inside. Yours also may have a accessory piece on top the reads "VORTEC" in orange letters.......

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Where is the oil sending unit located on the 2001 Chevy 4.3 vortec engine?

Where is the oil sending unit located on the 2001 Chevy 43. vortec engine?


What is spark plug gap for 2004 Chevy vortec 4200?

43 thousands of an inch


What are the torque specs on the plenum for the 454 vortec engine?

71 inch pounds the first pass...Then 13 foot pounds to finish it...71 inch pounds is aprox.6 foot pounds..


What is the fuel pressure suppose to be on a 1994 S-10 43 Vortec V-6 Blazer?

41 to 47 psi


Where can you find a schematic for the ignition control module of a 43 vortec engine in a 1994 Chevy Blazer S10?

Owners manual, positive.


Why do you keep getting random misfires on gmc 350 vortec 1997?

Distributer cap and rotors are common. Have seen reasonably new ones go bad on these. Also have seen leaking fuel rails under the plenum.


Where is the fuel pressure regulator located on a 1995 silverado?

It is located under the plastic intake manifold plenum. It is an internal design because it draws it's vacuum from within the plenum. New answer: A 1995 is TBI (THROTTLE BODY INJECTION)tHE REGULATOR WILL BE FOUND ONTOP OF THE TBI. HOUSING JUST BEHIND THE 2 INJECTORS.only the vortec engines have it under the upper intake plenuem.


Does a 2002 astro van have a vortec 4.3 or non vortec 4.3?

Vortec


Whats the plenum?

Starter is located underneath plenum.


Where is location of O2 sensor on 2003 GMC safari awd 43 vortec van?

in exhaust pipe in front of muffler / catalytic converter, changed mine yesterday.


What is the plenum on a 2002 Kia Sedona?

The plenum is the intake manifold.


Where are the injectors of a 1994 Chevrolet Blazer?

They are inside the inlet manifold (Penum) to get access you need to unbolt the top half of the penum .The bottom half can stay bolted to the engine block . the plenum is the curved inlet manifold with the throttle body attached to it & the vortec name plate on top. Inside the plenum the fuel injection lines of the multipoint injection system run to the injectors at the end of each line.