Left hand side of gearbox. You can get at it by turning the steering wheel full lock, and reaching in behind the back of the left hand front wheel. A squirt or two of contact cleaner/wd40 etc in the connectors should get it going again, or you'll need a 19mm spanner if you need to replace it. It's a 2 minute job, which makes a pleasant change :)
its behind the light switch its self its a pcb
CHECK SWITCH ON TOP OF CLUTCH PEDAL AS IT SOMETIMES GETS STUCK
you have to take to a rover dealer to put out the service light
The reversing sensor on a Rover 75 CDT is typically located in the rear bumper. It is designed to detect obstacles when the vehicle is in reverse and is usually positioned at a height that allows it to sense objects behind the car. In some models, you may find multiple sensors for enhanced detection. Always refer to the vehicle's manual for specific details about the location and functionality.
a fairly simple operation, remove n/s wheel and look towards wher the drive shaft goes into the gearbox [diff] . you will see a plug with 2 wires connected to the reverse switch that is screwed in from the rear, un plug the wires. you will need a deep reach 19 mm socet to clear the other part of the plug that is connected to the switch. un screw anti-clockwise and replace with new.hope this helps. the wiesel.
How do i time rover 75 v6 engine/
Disconnect the battery for 15 mins
Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180 Rover 75 Under bonnet fuel pump - WQB100482 - Roughly £180
Pry the the unit holding bulbs away from the car by squeezing and levering from the top.
yes
in my opinion yes, i got my 75 rover a while back and it still works perfectly
where is the parking buzzer located in the rover 75 .its somewere in the front but i cant find were as it has stoped working