follow the top radiator hose down to engine block. there will be a fitting there that you have to unbolt to get to thermostat. make sure to place new thermostat in housing the same direction the old one was facing.note whether gasket or o-ring went in front of or behind thermo. if gasket, it is best to coat it with permatex no. 2 gasket maker before installing. if o-ring simply install.
the fuel pump is located inside the gas tank of my 93 ford ranger
If you follow the top radiator hose torwards the motor,it will be hooked to the thermostat houseing.Remove the two bolts and the houseing and there it is.
the thermostat should have the long part facing down
follow the top radiator hose to intake ,its inside the thermostat cover.
The thermostat on a 1993 Toyota Celica can be found by following the outlet radiator hose. The thermostat on these cars are located at the bottom of the radiator.
Engine end of upper radiator hose
i had a 93 t-bird & the thermostat is located on the front of the intake manifold. just follow your top radiator hose back to it
The thermostat housing is located on the passengers side of the engine block, behind the timing belt.
On a 1993 Ford Ranger , 4.0 liter V6 engine : Follow the top radiator hose from the radiator , it connects to a metal pipe that is part of the engine cooling thermostat housing that is bolted to the front of the engine . The engine cooling thermostat is inside the housing
follow the top radiater hose
where is the horn relay on a 93 ranger
The computer on a 1993 Ford Ranger is located in the dash in the center just above the transmission hump. The computer is located just below the heater control panel.