To replace the vapor canister valve on a 2008 Ford Explorer Sport Trac, start by locating the valve, which is typically found near the fuel tank or on the charcoal canister. Disconnect the electrical connector and any vacuum lines attached to the valve. Remove the mounting bolts or clips securing the valve, then install the new valve by reversing the removal process, ensuring all connections are secure. Finally, clear any diagnostic trouble codes and test for proper operation.
The canister vent valve is located near the fuel tank. The canister purge valve is located on the engine.
The ORVR valve in a Toyota Camry is an on-board refueling vapor recovery valve. This valve is located in the upper portion of the fuel tank.
The expansion valve on a 1997 Honda Accord AC is located in line with the tube that supplies liquid coolant to the air conditioner vapor. It is mounted right beside the tube.
P0442 - EVAP CONTROL SYSTEM LEAK DETECTED ( SMALL LEAK ) possible causes : - damaged , cross threaded or loosely installed fuel filler cap - aftermarket EVAP hardware such as a fuel cap not conforming to Ford specifications - small hole or cut in fuel vapor hoses / tubes - canister vent solenoid stays partially open on closed command - loose fuel vapor hose / tube connections to EVAP system components - EVAP system component seals leaking ( EVAP canister purge valve , fuel tank pressure sensor , canister vent solenoid , fuel vapor control valve tube assembly or fuel vapor vent valve assembly )
Try replacing the PCV valve ( $ 3.00). It is located in valve cover. If they stick open it allows oil vapor to burn.
behind the rear tire on the drivers side under the mud flap
It is located directly in front of the fuel tank, on the frame above the purge vapor canister.
In the 2002 Hyundai Sonata, the vapor canister purge valve is typically located near the engine, mounted on or near the intake manifold. It is connected to the charcoal canister and the fuel system, usually found on the driver's side of the engine bay. For precise identification, it may be helpful to consult the vehicle's service manual or diagrams specific to that model.
in the fuel line up close to or on injector rail there should be what looks like a air valve, push it in until pressure is constant this will fix the vapor lock,but then replace gas cap
The vapor canister purge valve on a 2000 Mercury Mountaineer is typically located near the engine, mounted on the intake manifold or directly on the vapor canister itself, which is usually situated near the fuel tank. To access it, you may need to lift the vehicle or remove certain engine components for better visibility. It is connected by vacuum hoses and electrical connectors, so ensure to handle those carefully during inspection or replacement.
good luck left rear bumper no room for both hand took me 4 hours