0
What else can I help you with?
Where is the ECM located in a 1999 Chrysler New Yorker?
The last Chrysler New Yorker was made in 1996. A 1999 Chrysler has computers under the hood and inside the vehicle.
How do I reset the ecm in a 1989 Chrysler new yorker 3.0l v6?
You can reset the ecm with a scan tool or by unhooking the battery.
Does a 1988 Chrysler new yorker 3.0 have a map sensor?
Yes.
How much does a 1988 Chrysler new yorker weigh?
My '89 new yorker weighed 3280 lbs when I sold it for scrap this morning.
When was Chrysler New Yorker created?
Chrysler New Yorker was created in 1939.
Where is the fuel pump located on a 1988 Chrysler new yorker?
the fuel pump is located in the gas tank
Where is the thermostat on a 1988 Chrysler new yorker?
It is under the housing where the upper radiator hose hooks to the engine.
Where ecm on 1990 Chrysler new yorker fifth ave?
The engine computer is behind the battery. The transmission computer is under the hood on the passenger side.
Where is the ecm on a 1989 Chrysler new yorker?
The Engine Control Module (ECM) on a 1989 Chrysler New Yorker is typically located in the engine compartment, mounted on the firewall. It can be found on the driver's side, near the battery or near the rear of the engine bay. For precise identification, refer to the vehicle's service manual, as the location may vary slightly depending on the specific engine option.
Where do you put the transmission fluid in a 1988 Chrysler New Yorker?
through the tranny dipstick tube with a tranny funnel.
Does a 1991 Chrysler 5th ave new yorker have a chip in the ignition key?
No, a 1991 Chrysler New Yorker does not have chip key.
How many speakers does a 1988 Chrysler new yorker have?
The 1988 Chrysler New Yorker typically came equipped with a premium sound system that included a total of four speakers. Depending on the specific trim level and options, some models might have had additional speakers or enhancements, but the standard configuration featured four.
