what should high side on R22 on air conditiner
Unless you are epa certified you shouldn't add any r22 to your air conditioner. And if you are, you should probably already know... It depends on what type of unit it is. Is it a central split unit or a window unit?
The pressure for an R410a air conditioner system should be 118psi LP and 412psi HP. This is the same pressure as an R22 air conditioner.
Probably not, how long did it run before the mix up was discovered? All of the refrigerant has to come out and be properly disposed of, then a good evacuation and recharge. You did not say which refrigerant was the correct one for the machine, but either way it all has to go.
R-410A does not have a noticeable odor, as it is a blend of two hydrofluorocarbon refrigerants that are both colorless and odorless. If a leak were to occur, it is recommended to use proper leak detection equipment to identify the presence of R-410A in the air.
R22
The recommended suction pressure for R22 varies depending on the specific operating conditions and equipment. However, typical suction pressures for R22 range from 60-70 psi for air conditioning applications. It's important to consult the manufacturer's guidelines or an HVAC professional for specific recommendations.
Most home systems use R-22 refrigerant. R-410a, known as PURON, is also an increasingly used refrigerant. If you see a pink sticker on the outdoor unit, it will say on the tag with the model and serial numbers r22 or 410a. "Freon" is a trademark of DuPont, and is NOT the real name of refrigerant. "Freon" was R12 and is no longer made.
No
AnswerIt depends on what type you are looking for.Expect to spend between $5,000 and $10,000 for a unit and installation of central air according the site getproquotes.com
The boiling point of R22, a refrigerant commonly used in air conditioning systems, is -40.8 degrees Celsius (-41.4 degrees Fahrenheit).
r-22 (gentron), and r-410a (puron)