to check for leaks or in the case of the cooling system preasure cap to raise the boiling point of the coolant
If the cap is not holding pressure or if it is damaged, the engine will overheat. The automotive cooling system must be pressurised, WHY?? its because when you pressurise the fluid, the boiling point will increase.
A plastic radiator will crack under extreme over heat conditions for example a defective thermostat or bad cylinder head gasket will cause a cooling system to over pressurise and rupture.
to increase the waters boiling point
Motor cooling system? The engine cooling system consits of the water pump, radiator, hoses, cooling fans, etc.Motor cooling system? The engine cooling system consits of the water pump, radiator, hoses, cooling fans, etc.
The cooling system.
An average life of a system cooling device is around 10 to 15 years. This is with cont use of the system cooling device, if you do not use the cooling system then you can prolong your cooling system for a couple more years.
no
To re-pressurise your water system, first, turn off the water supply and locate the pressure gauge on your system. If the pressure is below the recommended level (usually between 1-1.5 bar), open the filling loop valves to allow water into the system until the desired pressure is reached. Once achieved, close the valves and check for any leaks. Finally, turn the water supply back on and ensure the system is functioning properly.
If there is no cooling system, the engin will overheat.
what is the purpose of pressurizing a cars cooling system
describe a cooling system with a diagram
Need to know more about the cooling system to answer this question.