0
What else can I help you with?
Why does oil spray out of the front exhaust manifold bolthole on a dodge slant six?
put a bolt in the hole and it wont spray out anymore
Why does a 1969 dodge slant six spray oil from the front exhaust manifold bolt hole?
There should be a stud (not a bolt) threaded in to the head and the stud should have a thread sealant applied to the threads.
How do you replace the intake manifold gasket on a 87 d100 slant 6?
remove the intake and exhaust manifolds. there are bolts that attach them onto the head and there are bolts near the carburetor that attach the intake manifold to the exhaust manifold.
Will a 1970 225 exhaust manifold fit a 1968 225?
It's likely. The 225 slant 6 had few changes in those years.
Where exactly is the O2 sensor on an 87 Dodge D150 slant 6?
The oxygen sensor on the 1987 Dodge D150 1/2-ton pickup with 2-wheel drive and a 3.7 liter 1Bl 6-cylinder engine is mounted in the exhaust manifold, next to the transmission bell housing. Check under the hood in the rear engine area on the driver's side.
Can you remove a smog pump on a dodge slant six to pass inspection?
The smog pump is designed to help clean the air the exits the exhaust. It might actually be detrimental to remove it if you have to pass emissions testing.
Timing chain on dodge slant six?
a slant 6 does in fact have a timing chain but it rarely ever wear out, break, or stretch, because of the durability of a slant 6.
D100 freeze plug location?
Assuming this is a V8 motor, the freeze plugs will be located on either side of the block (3 each side) just below the exhaust manifold. On a slant 6 I'm not 100% sure if they are on both sides of the block or not.
What color is 1965 dodge truck slant six engine?
teal
What is the bolt pattern on 1970 dodge dart slant 6?
5x4
Did thy put a slant 6 in a 1969 dodge dart gt?
yes I believe you could order the slant six in the GT in 69.
How do you tell the size of the engine in 1967 dodge coronet 440?
if no markings on the front fender it is either a 225 slant six, 318 or a 383 2 bbl., all other engines had a front fender emblem stating the engine size.
