A flight engine stops running after it has been stopped by a pilot.
The injectors in them are known to drip after you turn off the engine, after its been running for a short period. Pull the fuel pump relay, crank the engine for a bit and it should clear the flood. Or buy new injectors.
Usually, a jeep's engine stalls in idle mode because of a battery power fault or because there is no gas. However, it is common for any car to stall when it has not been running for a period of time and the engine is cold.
If the check engine light is flashing with the engine running , that means a spark plug misfire has been detected
If the check engine light is flashing when the engine is running , that indicates that an ignition misfire has been detected
Sounds like the engine heats and the ignition fails.
No, check it after the engine has not been running for at least 15 minutes.
It can be a leaking injector that floods the engine when it isn't running. GoodluckJoe They asked about a problem that occurs AFTER it's been running a while...not after it's been sitting, with a pressurized Fuel line.
If the check engine light is flashing on and off with the engine running , that means that an engine cylinder misfire has been detected
Means to start the engine while it is cold (And has not been running for a few hours so the engine has gone cold)
If the check engine light is flashing every second or so with the engine running that means an engine cylinder misfire has been detected
If your check engine light is blinking that means an ignition misfire has been detected