Need to know what year 318 you have to help you.
Turn the key on but do not start the truck then slowly press the gas pedal to the floor 3 times
if it has a carburetor it is normal
start the engine and press the gas pedal while it is in park
put bike on stand turn key to on position press and hold brake pedal on floor bored press start button
Turn key on, engine, off. Press gas pedal to the floor, 3 times within 10 secs. Start vehicle, and the oil light should be off.
Key on, engine off. (if push button start, press button twice without touching brake) press gas pedal to the floor three times.Key on, engine off. (if push button start, press button twice without touching brake) press gas pedal to the floor three times.
To reset the light, turn your ignition to on, then press the gas pedal 3 times, then start the car. To reset the light, turn your ignition to on, then press the gas pedal 4 times then you will hear a beep, then start the car.
To start the car, first make sure the car is in park or neutral. Insert the key into the ignition and turn it clockwise until the engine starts. If your car has a push-button start, press the brake pedal and then press the start button. Make sure to release the key or button once the engine is running.
Many cars require you to press the gas pedal when starting the car. It's quite normal.
If you turn the ignition to the on position, and then press the interlock button, you don't have to press the clutch pedal down to start the truck.
On cars with a carburetor you must press on the gas pedal to activate the choke, cars with fuel injection do not have a choke so this is not necessary.
If u have the 24v then all you should need to do is press the gas pedal while turning it over may take two or three times for a few seconds.