answersLogoWhite

0

take dist. cap off see if rotor turns as your engine turning over no movement in rotor might mean oil pump frozen pull dist. see if drive shaft broke

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Your engine does not crank when you turned on the engine but when you connect the solenoid to the battery the engine cranks?

Sounds like you might have a bad starter relay.


Why will engine not crank when trying to start?

Diagnosis: Engine Won't Start or Run Check related link below


You are trying to find the crank shaft positioner sensor?

look at the front (with the pulleys) of th engine


Will a Crank position sensor make a engine not crank?

No, it will crank, but it will not start.


What might cause 1992 Ford Tempo crank shaft pulley not to turn when engine is on but accessories turn by hand when engine is off?

If you mean ... why the crank won't turn when the key is on and the acc.'s will turn, Well sounds like crank shaft is locked up. When the crank bearings try to pile up on each other and jam the crankshaft in it's final resting place, till rebuild.


94 wrangler won't go into gear when I crank it then push the clutch in. But if I push the clutch in then crank the engine it goes it gear fine. I have already changed the master and slave cylinders?

It sure sounds like your clutch is worn


What causes a 2000 Chrysler cirrus fuel injection starter fuse to blow?

If it blows when trying to crank the engine, the starter is probably the failure.


Where is your crank shaft located on a 2000 ford expedition?

The engine crank shaft is inside the engine


What causes a C320 car not to start at times even though it sounds like it's trying to start What causes the check engine to stay on for awhile and no malfunctions show on the monitor?

Most likely the crank sensor bu you must scan the vehicle while the problem is happening to get the code


Dodge PU 5.9 liter engine poppednow won't crank turns over like starved for gas?

Check engine timing, sounds like timing chain might have jumped a tooth


Where is the location of the Crank Sensor on a 3.1 Corsica Engine?

The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.


Weres the crank sensor on a 96 2.4 pont engine?

The crank sensor is located at the left front of the engine