0
That's extremely high pressure on the low side. While I believe there's still a good chance that you have an AC problem, I'm more inclined to believe that you have a faulty manifold gauge set than I am to believe your compressor isn't putting any pressure to the high side, and the low side pressure gauge may be faulty, as well. Tools are something where you get what you pay for - if you bought your gauge set at a place like Harbor Freight or Wal Mart, don't be surprised if it's faulty.
What else can I help you with?
Does running a needle through your hair sanitize the needle?
Eeeew, No! If anything, it would coat the needle with any oil naturally present in your hair.
What happens to an aneroid barometer when air pressure changes?
When air pressure increases, the metal aneroid capsule in the barometer contracts, causing the needle to move towards high pressure. Conversely, when air pressure decreases, the metal capsule expands, causing the needle to move towards low pressure. This movement of the needle indicates changes in atmospheric pressure.
What is a pressure needle in checking blood pressure?
There is the blood pressure cuff which wraps around the arm and the pressure guage I believe is called a "sphygmomanometer"
Why does a balloon burst when pricked with a needle?
Because of the small area of the needle and the force that is exerted on the balloon. The pressure inside the balloon that was previously more, finally can diffuse into the room. Since the air canot all escape from the needle prick it bursts to equal the pressure.
The safe working pressure range for a needle gun is?
80-110psi
Where is the needle on the oil pressure gage should be while driving?
Y40
What happens to an aneriod barometer when air pressure changes?
When air pressure increases, the aneroid barometer contracts, causing the needle to move clockwise or indicate a higher pressure reading. Conversely, when air pressure decreases, the aneroid barometer expands, causing the needle to move counterclockwise or indicate a lower pressure reading.
Who made the running stitch?
if you don't have an 'eye' for evenness, take a ruler and draw a line with a removable ink pen. thread your needle and know the end. poke the needle up on the line and then down again a distance down the line you made. repeat for the length of the line. it will look like... _ _ _ _ _ _ _ _ _ _
Why is my Keurig running really slow?
Your Keurig may be running slow due to a clog in the machine's water line or needle. This can happen if there is a buildup of mineral deposits or coffee grounds. Try descaling the machine and cleaning the needle to improve its performance.
Tattoo needle stick out of the gun?
The tattoo needle should stick out of the gun (tube tip) about 1 to 2 millimeters when at rest, and slightly more when the machine is running due to vibration.
Why is your oil pressure gauge going haywire in your 2003 silverado?
AnswerWhat do you mean by haywire? Without more information, all I can tell you to do right now is to replace the filter you are using with an AC/Delco filter. The oil pressure sending unit may be defective if you are getting erratic readings. I mean that the water temp gauge needle goes way past the point to where it bottoms out and so does the battery volt gauge needle and the oil pressure gauge needle and the tach needle works when it wants to.
When is the intracranial pressure of the skull measured during a lumbar puncture procedure?
This pressure is always measured immediately upon insertion of the LP needle.
