answersLogoWhite

0

If you raise the back end higher than the front end, no.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Do you have to change the drive shaft when you replace the drive shaft oil seal on a 2006 Nissan navara?

No you do not.


Where is the oil pump on a 1998 Jeep Wrangler?

Inside the engine oil pan, at the bottom of the distributor drive shaft.Inside the engine oil pan, at the bottom of the distributor drive shaft.


How do you remove the drive shaft on a 1999 Ford f150 Ford?

Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.


Can water get into the oil through the drive shaft of a Honda rancher 350?

any of you honda atvs or utvs that have a rubber boot on the drive shaft can get water in the engine oil through the smallest of cracks, tears, or holes in the boot. Especially if youre doing extensive travel in mud and water. If you have water in your oil thats where i'd look first( inspect the drive shaft boot)


How do I replace the oil seal on the drive shaft from the motor into the hyraulic transmission on Massey Ferguson GC2300 tractor?

To replace the oil seal on the drive shaft of a Massey Ferguson GC2300 tractor, first, ensure the tractor is turned off and securely supported. Remove the drive shaft from the hydraulic transmission by unscrewing any retaining bolts and gently pulling it out. Once the shaft is removed, use a seal puller to extract the old oil seal from its housing, then clean the area thoroughly. Finally, install the new oil seal, ensuring it is seated properly, reassemble the drive shaft, and tighten all bolts to the manufacturer’s specifications.


Amount of gear oil in shaft drive Yamaha 650 v star?

3 quarts


Where is the oil tank located on the 1990 Yamaha VMax motorcycle?

there is no oil tank on a Vmax motorcycle. The only oil is in the crank case, and the shaft drive.


95 Chevy PU Front drive shaft is leaking why Already replaced rear seal on transmission. Oil coming from rear seal just the front of the drive shaft. Looks like from the inside of drive shaft.?

if leaking out small hole in middle of front driveshaft yoke, check o-ring in cup on output shaft. have to remove extension housing.


When removing the CV Half shaft for a Nissan Altima 1998 is oil dripping out normal from the trans axle?

yes it is quite normal for oil to run out, if oil did not come out it would be more serious. After replacing the shaft be sure to top up the oil level again.


Is the engine and transmission oil the same in a 1981 GL1100 Honda Goldwing?

Yes, it is. However, there is separate gear oil in the final drive of the Goldwing, as it is shaft driven.


Why don't you see oil pumping when you remove the valve covers on a 88' Chevy 305?

Plugged oil pump screen,plugged oil pump itself, broken drive shaft for the oil pump ,broken drive coupler for said pump. no oil in oil pan .plugged oil passages in engine block.


How do you remove the right front drive shaft on a 1990 LeBaron in order to remove and replace the power steering pump?

you can replace power stering pump without moveing drive shaft but its fiddly. to remove drive shaft undo 30mm nut in centre,undo bottom ball joint and pull strut out of way be ready to catch gear box oil.