system running hot fans not running
If your cooling system stops working, your engine will likely overheat, leading to potential damage and breakdown. It is important to address cooling system issues promptly to prevent severe damage to the engine.
The cooling system helps keep the car from running too hot. A diagram for the 1998 Ford Taurus cooling system can be found in the car's maintenance or repair manual.
The purpose of the AC drain pipe in a cooling system is to remove excess moisture that accumulates during the cooling process, preventing water from leaking or causing damage to the system.
The purpose of a condensation pipe in a heating or cooling system is to remove excess water that forms during the process of heating or cooling, preventing water damage and maintaining the efficiency of the system.
No, you cannot put Pepsi inside of your car's cooling system. This could seriously damage if not make your vehicle inoperable.
Not if the cooling system is operating properly.
In the cooling system it transfers heat out through the radiator. If mixed with the gasoline, it can cause rough running or no start. If pulled in through the air filter it can cause a catastrophic failure.
this sounds like a bad thing to me...like the reservoir and/or the cooling system, has no antifreeze in it and heat from the engine is exiting through the cooling system. Does your temperature gauge read in the normal range? Is the car running OK? FriPilot
This is the result of a dirty cooling system. Corrosion is occuring in the engine block and a cooling system flush is required. Always use a good quality corrosion inhibitor in your cooling system to prevent overheating and possible head gasket damage.
If no liquid in the cooling system, then the heads are probably warped and the engine is ruined. If running straight water and no antifreeze, then permanent damage unlikely unless the temps have been cold enough to freeze the water in the engine (popping the freeze plugs), or the engine has gotten hot enough to boil off the water in the cooling system. 50/50 mix of distilled water and antifreeze is necessary to prevent freezing, boil-over, and cooling system corrosion.
The cooling system of a hydro-generator is one that is done through channels. It is sent through rotor steels. This is essential when it comes to passing air along quickly.