same thing on my 2002 took it back to the dealer and they replace the hub bearing assy and wiring harness to the abs sensor this is a tsb
Begin by removing the wiring harness from your traction control box. Remove the traction control box retaining bolts. Reverse the process to install your new traction control box.
Traction control, when engaged "senses" when a driving tire has no traction. The system will then compensate for this by slowing the spinning wheel through partial application of the brake, reducing power or both. The system uses wheel speed sensors to monitor the wheel speed. When traction is lost the sensor prompts the brake computer to partially apply the brake to the wheel that is spinning, allowing it to gain traction. Sort of like Antilock brakes in reverse.
The R off button beside the TC (traction control) is the reverse sensor and beeper.
pry out the control switch and disconnect the electrical connectors.install is reverse.
A Traction Control System or TCS. Is the system that helps your wheels from skidding while riding in water or other slippery areas. It also helps your tires from skidding or making the scratching sound when for say, "Taking off fast from a red light". Traction control is an option on many cars today. When engaged, it "senses" when a driving tire has no traction. The system will then compensate for this by slowing the spinning wheel through partial application of the brake, reducing power or both. The system uses wheel speed sensors to monitor the wheel speed. When traction is lost the sensor prompts the brake computer to partially apply the brake to the wheel that is spinning, allowing it to gain traction. Sort of like Antilock brakes in reverse.
It only allows starting in park and neutral, and runs the reverse lights.
Reverse rotation Dana 44 twin traction beam
Replace the bulb first, if this does not work try the reverse switch.
Pull the plastic trim that surrounds the radio and center stack, remove the screws that hold it in, pull it out and unplug it. Reverse to install.
It depends on which bulb you wish to replace. Headlamp, stop light, reverse light, heater control illumination? This question is "too general" to answer.
No you do not.
Remove the tire and wheel. Jack the frame of the automobile off, so there isn't any way on the suspension. Remove the control arm retaining nuts. Reverse the process to install the new control arm.