No, you cannot put 14-inch tires on a Yamaha Grizzly that is designed for 25-8-12 on the front and 25-10-12 on the rear. The numbers indicate the tire diameter in inches, and switching to 14-inch tires would not fit the wheel specifications of the ATV. It is important to stick to the manufacturer's recommended tire sizes to ensure proper handling, safety, and performance.
The VIN is located on the bar in between the front 2 wheels of the Yamaha Grizzly 660. The VIN will be displayed on a green sticker.
Front is 25x8x12 and Rear is 25x10x10
The 2001 grizzly 600 ATV is "Air Cooled". There is no coolant. The little radiator in the front is an oil cooler.
For a 2002 the factory spec is 190 ft/lbs
The gear ratio is 3.60:1, this is for the front limited slip differential.
Its right in front of the handlebars. There is a plastic compartment you can pop open to access the battery pretty easily.
The Vehicle Identification Number (VIN) for a Yamaha 660 Grizzly is typically located on the frame, specifically on the right side, near the front of the vehicle, just below the seat. It can also be found on the engine or in the owner's manual. Always ensure to check these areas for the most accurate VIN information.
yes it can but you can buy new on amzon for a great price. You can also purchase them from American CV
According to the parts man at Yamaha who I talked with today, the number is on the frame on the left side by the footpegs. This was for a Warrior 350, but may work for your model too. For my Yamaha Moto-4 350 - the VIN is located on the frame, adjacent to the (rear side) of the left front tire.
front or rear diffs take approximately 320cc. fill the diffs till the oil runs out the filler hole, it will find its own level.
The VIN (Vehicle Identification Number) on a Yamaha Grizzly 700 is typically located in two main places: on the frame, near the right front wheel, and on a label attached to the left side of the frame, near the footrest area. You can also find it on the registration documents and title for the vehicle. It's essential to check these locations to ensure accurate identification of the ATV.
To remove the seat on a Yamaha Grizzly 450, first locate the seat release mechanism, usually found at the back of the seat. Use a wrench or your hand to loosen the bolt or pull the latch. Once released, gently lift the seat from the rear and slide it forward to detach it from the front hooks. Make sure to check your owner's manual for specific instructions related to your model.