no....never use a solvent when working gas lines
on air conditioners you silver braze the copper lines
Yes, natural gas can corrode solder on copper pipes over time. This is due to the sulfur compounds present in natural gas that can react with the copper and cause deterioration of the solder joint. It is essential to use approved materials and proper installation techniques when working with natural gas lines to prevent corrosion issues.
Easier to solder /braze/ flair / compression
No, copper is a better conductor of electricity than silver. Copper has a lower electrical resistivity compared to silver, making it more efficient for conducting electricity. This is why copper is widely used in electrical wiring and transmission lines.
The different types of toilet water supply lines available for installation include flexible braided stainless steel lines, rigid copper lines, and plastic lines.
Coins (pennies), buttons, copper wire, Electromagnets, Printed circuit boards, Lead free solder, alloyed with tin. Electrical machines, etc --- Many countries use copper in their telephone lines, copper piping for water transfer and heating
Aluminum is a good conductor of electricity similar to copper. It is often used in power transmission lines due to its conductivity and lower cost compared to copper.
possibly a valve was not opened fully or the copper became kinked or solder entered the piping or thew lines were not properly flushed out or the aerator is blocked or the tubing is way undersized
Galvanized pipe will be silver/gray color. Copper will be copper. Use a magnet, it'll stick to galvanized pipe but not to copper. Drinking water lines should not be black steel pipe.
Silver is the best conductor of electricity, with copper a close second. Gold is third on the list followed by aluminium. Power distribution systems commonly use copper for underground power lines and aluminium for overhead lines.
Only non acidic core and non resin core solder may be used. 2mm to 4mm solid solder is recommended.
No. Regardless of what type of supply line you use between the house supply and the faucet it will be a compression fitting. Copper lines with a nut and ferrule or flexible ones are both compression and do not need tape or pipe dope.